emiellr

Interesting piece. Thanks for sharing 🙏

Yeah looking back, this isn’t my best take probably. As you say though, it is a free service.

You can, but only 10 images per hour. You’d be doing some wild shit to go over those 10 per hour.

Braindead take

For good bed adhesion I think I have a couple pieces of advice:

• Get a PEI bed if you don’t already have one. It makes a world of difference.
• If that doesn’t stick well, consider getting something like this
• Make damn sure your bed is level
• Make sure the Z offset is properly set up
• If you aren’t already, start by printing PLA, then move on to other filaments once that goes well.
• Make sure you have proper temperatures for both the hot end and the bed. Normal values for PLA are 210-230 on the hotend and 50-60 on the bed.

Tbh I’m a bit lost on the purpose of this

Wait now hold on a minute. Why would I want to do this? Is this activism by people against LLMs in general or…? I’m confused as to why I would want to do this.